Need help with ZOOM TUBES...

Status
Not open for further replies.
SonicX8000

SonicX8000

Graphic & Sprite Modder.
Judge
I made a zoom tube but when I test it out it always ends in the 1st way point.

How can I select the order of the way points? Do I just left click on them or sumthing?

Also, I been restarting the zoom tubes and after aobut 50 times, still the same thing.
 
Every one is asking about this. Its getting a bit annoying. You need 2 waypoints, one at ether end. Then use the zoom tube wizard to help you with the rest.

Solved.
 
That happens to me too, and it has been confirmed by SSNTails and Oogaland that it was probably a bug that happens with Zoom Tubes.
 
Status
Not open for further replies.

Who is viewing this thread (Total: 1, Members: 0, Guests: 1)

Back
Top