• Do not use Works in Progress as a way of avoiding the releases system! Works in Progress can be used for sharing early betas and for getting suggestions for improvement. Releases of finished content are not allowed in this forum! If you would like to submit a finished addon, click here for instructions on how to do so.

Segment violation

Status
Not open for further replies.
Shuffle

Shuffle

Developer
Sonic Team Junior
Okay I have a Segment Violation problem..

See, I have a wad that works just fine and everything works but then, I open up Wadauthor and make a VERY small change (like moving the player 1 start one square away) and then save. When I try to run the wad again, I get a Segment Violation.

Any help would be much appreciated

-Thanks :D
 
Segment Violations are generic errors that can be caused by lots of things. I can't help you with that one unless you send the wad.
 
Nevermind, it works now.
It had nothing to do with the wad, I had to re-install Wadauthor.
 
Man...this is just so funny! I don't think SRB2 Doom Builder was even AROUND back when this topic was made!
 
I'll Begin said:
Prove it.
Click to expand...
:<

I'm sorry sir. I was just kidding... Didn't you get the irony?

*grumbles*

fawfulfan said:
Man...this is just so funny! I don't think SRB2 Doom Builder was even AROUND back when this topic was made!
Click to expand...

Then, you should've seen the "How do I jump in 2.0" that mahmah had posted :D
 
Holy WHAT!? You say SRB2 will be in THREE DEE!?
Seriously though, the troll was taken care of, locked topic, etc.
 
Status
Not open for further replies.

Who is viewing this thread (Total: 1, Members: 0, Guests: 1)

Back
Top