example text for maincfg?

Status
Not open for further replies.
Are you sure you placed it at the right spot and looked at the right spot? In any case, post your emblem block.
 
Well, the Z position should of course be set so that the emblem will actually show up. If you put it in a place where the floor is higher than zero and set the Z position to 0, it will be somewhere below the floor.

Also, please just copy all the lines that you wrote in the MAINCFG (for the emblem). It should look something like this:

EMBLEM 1
X = 5000
Y = -2000
Z = 1024
PLAYERNUM = 0
MAPNUM = 1
 
The Z position is say, If you make a floor have a height of 0, then put Z = 0, the emblem will show up above the floor because the floor height is 0 and the z position is 0. Setting the Z position to 200 would make the emblem be at 200 fracunits.
 
Status
Not open for further replies.

Who is viewing this thread (Total: 1, Members: 0, Guests: 1)

Back
Top